3.4
Programming stations to preset buttons
•
Manual programming
1. Select the desired band from FM1, FM2, AM1
and AM2 using the "AM/FM" button.
Z21762
Z11564
2. Make the frequency of your desired station
appear on the display by using the "
tuning button.
: Press this button for higher frequencies.
: Press this button for lower frequencies.
If you give the "
(more than 1 second) and then release it, the
radio starts automatic tuning after a short beep
and will then stay tuned to the first receivable
station.
Z21763
Z11564
NOTE:
Use manual tuning if you cannot tune to a desired
station by automatic tuning due to poor signal
reception.
3. Give the desired preset button a long press. A
short beep will sound indicating that the
selected station has been programmed to the
button.
NOTE:
•
If you program a new station to a preset button
to which another station has previously been
programmed, the original station will be auto-
matically cancelled.
•
If the battery is disconnected or the associated
Z21077
Z11564
fuse is removed, all stations programmed to pre-
set buttons are erased from memory and you
will need to program the stations again.
" or "
" button a long press
10-21
" or "
"