Mitsubishi Fuso CANTER Owner's Handbook Manual page 257

1.5 Channel selection button
Press this button. The radio will tune in to one of the
stations programmed in memory. The station's fre-
quency and the number of the associated channel
are indicated in the display.
Z11566
1.6 Tuning buttons
•
Every time either button is pressed for a period
shorter than one-half second, the frequency
changes while being indicated in the display.
The frequency changes in either 5-KHz units or
9-KHz units for the AM bands and in 0.1-MHz
units for the FM bands. Press the
button to lower the frequency or the
raise it.
•
When either button is pressed for half a second
or longer, a beep is emitted and the radio starts
Z11564
scanning for a station. The radio stops scanning
when it finds a station whose signal is good
enough for reception.
1.7 AS button
When the AS button is held pressed for two or more
seconds, the radio generates a short beep and
starts tuning in automatically to receivable stations
one after another while programming the stations
on the channel selection button, the lowest fre-
quency station first.
Z11567
10-5
side of the
side to
P. 10-8