Mitsubishi Fuso CANTER Owner's Handbook Manual page 446

8. Open the door, then tighten the screws
behind the front and side turn signal lamp
Z21135
CAUTION
•
Press the front and side turn signal lamp
fully in toward the centerline of the vehicle. If
the lamp was not pressed fully into place
and you opened the door, the door could hit
the lamp and damage it.
•
Do not tighten the screws too tightly or the
mounting could get damaged.
9. Fit the lamp rubber
onto the tabs
of the vehicle.
10. Fit the rivet
Z21140
1.2 Headlamp bulb replacement
CAUTION
•
Do not directly touch the glass part of a halo-
gen bulb with your fingers. Any oil and other
substances contaminating the glass surface
could shorten the bulb's service life.
•
Do not clean lamps with alcohol and thinner,
because their lenses are made of plastic.
•
Do not attach any sticker or tape on the
headlamp lens. Doing so may result in defor-
mation of the lens by heat since the lens is
made of plastic.
under the headlamp
by moving it toward the outside
, then press in the screw
13-27
.
.