Mitsubishi Fuso CANTER Owner's Handbook Manual page 155

1. Select the outside air temperature mode
pressing the MODE switch
Give a long press on the SET/RES switch
display the adjustment screen
2. Select the adjusting/setting item using the SET/
RES switch. Each time you press the SET/RES
switch, the display changes in the following
sequence:
Temperature unit selection
selection
•
The temperature unit can be changed between
degree Fahrenheit (°F)
(°C)
SELECT switch
selection screen
•
The bottom-left display can be changed between
temperature and time indications by pressing
either the MODE switch or SELECT switch on the
time/temperature selection screen
•
Method for setting temperature alarm on/off
On the temperature alarm on/off setting screen
, press the MODE switch to activate the out-
side air temperature alarm and press the
SELECT switch to deactivate the alarm. Once
the alarm is activated, you can set an alarm
temperature between –5°C and 5°C
and 41°F). The alarm is issued by the tempera-
ture indication at the bottom-left on the screen
flashing for about 1 minute when the set temper-
ature is reached.
3.4 DPF monitor
This display mode indicates the amount of PM in
the DPF, a prompt for performing parked DPF
regeneration, and the predicted time until comple-
tion of parked DPF regeneration. If the situation
requires, the DPF monitor also provides the driver
with necessary warnings and indications.
Z22080
•
If the DPF contains PM equivalent to 7 or more
segments of the indicator, a message is dis-
played prompting you to perform the parked
DPF regeneration.
See page 5-52 or 5-62 (vehicles with a BlueTec
system) for details about the DPF.
Z22081
→ Time/temperature
→ Temperature alarm on/off setting
and degree Celsius
by pressing the MODE switch or
on the temperature unit
.
6-13
by
.
to
.
.
(23°F
®