Mitsubishi Fuso CANTER Owner's Handbook Manual page 167

1. Firmly apply the parking brake and move the
gearshift lever to "P".
2. Turn the starter switch to "ACC" or "LOCK".
3. Turn the starter switch to "ON".
4. If the warning remains displayed but driving in
the manual gearshift mode is possible, take the
vehicle to an authorized MITSUBISHI FUSO
distributor or dealer for inspection as soon as
possible.
5. If the warning remains displayed and gear shift-
ing is impossible in the manual gearshift mode,
contact your nearest authorized MITSUBISHI
FUSO distributor or dealer.
2.6 SAM warning
NOTE:
SAM, which stands for Signal Detect and Actuation
Module, is a module that integrates the control and
power distribution functions for the electric equip-
ment of the cab and truck body.
•
Red warning
The red SAM warning is displayed when a failure
occurs in the electric control system of the SAM.
If this warning appears while driving, stop the vehi-
Z21714
cle in a safe place and do the following:
1. Firmly apply the parking brake and place the
gearshift lever in the neutral position (manual
transmission vehicles) or in the "P" position
(vehicles with a DUONIC system).
2. Turn the starter switch to "LOCK".
3. Turn the starter switch back to "ON". If the indi-
cation goes out, there are no problems. If the
warning remains displayed, contact your near-
est authorized MITSUBISHI FUSO distributor or
dealer immediately.
•
Amber warning
The amber SAM warning is displayed when a failure
(of a type that requires inspection of exterior lamps)
occurs in the electric control system of the SAM.
If this warning appears while driving, stop the vehi-
cle in a safe place and do the following:
1. Firmly apply the parking brake and place the
gearshift lever in the neutral position (manual
transmission vehicles) or in the "P" position
(vehicles with a DUONIC system).
2. Turn the starter switch to "LOCK".
3. Check the exterior lamps for abnormalities.
Replace a blown lamp if any.
4. Turn the starter switch back to "ON".
6-25
P. 13-20