When Servicing The Vehicles With 12-Volt And 24-Volt Power Circuits - Mitsubishi Fuso CANTER Owner's Handbook Manual

When servicing the vehicles with
12-volt and 24-volt power circuits
<Vehicles with a battery equalizer>
Handling of vehicles equipped with 12-volt and
24-volt power circuits
If there is a battery equalizer
your vehicle is equipped with 12-volt and 24-volt cir-
cuits. The 12-volt power supply is used by the
equipment in the cab and the 24-volt power supply
by the equipment to be installed on the vehicle
body. Refer to the section "When a fuse has blown"
on page13-11.
CAUTION
Consult an authorized MITSUBISHI FUSO dis-
Z21950
tributor or dealer before installing electrical
equipment. If you carry out wiring by yourself to
install commercially available electrical equip-
ment, the equipment may malfunction or the
wiring overheat, which could cause a fire in the
worst case.
NOTE:
•
If the battery has run down, use a vehicle with a
12-volt power source to jump-start the engine.
Do not use a vehicle with a 24-volt power
source. Refer to the section "When the battery
has run down" on page 13-33.
•
When replacing the battery, follow the procedure
given in this handbook.
Refer to the section "Battery – check" on page
12-102.
1-17
next to the battery,