Mitsubishi Fuso CANTER Owner's Handbook Manual page 258

10-6
Interior equipment and accessories
1.8 Band selector button
•
The radio can receive broadcasts at frequencies
within four frequency bands: two AM bands
(AM1, AM2) and two FM bands (FM1, FM2).
The selected band is indicated in the display.
•
Every time the band selector button is pressed
for a period shorter than two seconds, the
reception mode changes from AM to FM, and
vice versa.
•
If the button is pressed for a period shorter than
two seconds while the radio is receiving a
broadcast and the display is showing the time,
the indication changes from the time to the fre-
quency. If the button is then not pressed for
approximately five seconds, the indication
changes back to the time.
•
When this button is pressed for two or more sec-
onds, the clock is readied for time setting.
Z11568
1.9 MEMO button
•
The MEMO button is used in conjunction with
the channel selection button for programming a
station into memory (See section 1.10).
•
The MEMO button is used also when the clock
is set in accordance with a radio time signal.
Z11569
1.10 How to program stations
You can program the channel selection button by
either of two methods: a method using the MEMO
button and a method using the AS button for auto-
matic programming.
NOTE:
For the AM mode as well as FM mode, a total of
twelve stations are programmable on the channel
selection button (six stations in the AM1 or FM1
band and six in the AM2 or FM2 band).
P. 10-10
P. 10-11