Mitsubishi Fuso CANTER Owner's Handbook Manual page 333

10. Let the engine idle allowing oil to circulate
throughout the engine parts. Then, stop the
engine and wait for more than 10 minutes before
checking the oil level again. Also check for pos-
sible oil leaks.
11. After adding oil to the correct level, ensure that
the drain plug, oil filler cap and oil level gauge
are securely installed.
12. Reset the engine control unit. See 1.4 "Reset-
ting the engine control unit" for the method.
CAUTION
•
Take care not to add more than the specified
quantity of oil. The engine can be severely
damaged if the correct engine oil level is not
maintained.
•
If the engine is frequently run at high speeds
or under heavy loads, the engine oil will
deteriorate quickly and must be replaced
sooner than specified.
•
When adding engine oil, take care not to spill
it. If oil is spilled on a belt, the belt will slip
on pulleys.
WARNING
Take care not to spill engine oil as engine oil
on the exhaust manifold or other hot sec-
tions of engine could catch fire. Wipe clean
the oil if spilt.
1.4 Resetting the engine control unit
1. Turn the starter switch to "ON". Do not start the
engine.
2. Depress the accelerator pedal to the floor and
keep it there for at least 20 seconds.
3. While still keeping the accelerator pedal
depressed to the floor, pump the brake pedal at
least 6 times.
When the engine control unit is reset, the
indicator (amber) appears on the display for
about 10 seconds.
NOTE:
The engine control unit calculates the engine oil
replacement time. The steps above are necessary
in order to reset the data used for determining the
engine oil replacement time.
12-31