Mitsubishi Fuso CANTER Owner's Handbook Manual page 108

5-42
Switches and controls
CAUTION
Keeping the headlamps on for a long period
without the engine running can drain the bat-
tery, making the engine impossible to start.
The lighting switch can be used with the starter
switch in any position.
Turning the knob at the end of the lever controls the
illumination of lamps as follows:
position
position
3 Passing signal/dimmer switch
•
Passing signal
Pulling the lever up activates the high beams until
the lever is released. Use this to flash a signal when
overtaking another vehicle.
•
Dimmer
With the headlamps illuminated, pushing the lever
down activates the headlamp high beams and pull-
ing it back to the original position reactivates the low
beams. When the high beams are on, indicator
Z20983
lamp
4 Turn signal lamp switch
•
Turn signal
Moving the lever forward or backward activates the
corresponding turn signal causing it to flash. At the
same time, the corresponding indicator lamp
flashes.
When the steering wheel is returned to the neutral
position after a right or left turn, the switch automat-
ically moves back to the neutral position and the
lamp stops flashing. After making a moderate turn,
Z20984 however, the switch will sometimes not return auto-
matically. In this case, put the switch in the neutral
position by hand.
•
Lane changer
Lightly pushing the lever forward or backward
causes the corresponding turn signal lamp to flash
while the lever is held in this position.
Clearance, tail, license,
end out-line marker
<Vehicles with end out-
line marker> and meter
illumination lamps
On
On
lights up.
Headlamps
Off
On
or