Table of Contents
Advertisement
PROGRAMMABLE SERVICE INTERVAL
The service interval counter is programmed to 25 hours at the factory. As hours
of engine operation increase, the counter decreases. The wrench icon will flash
for about 10 seconds when the counter reaches zero (0), and each time the key
is turned on thereafter, until the counter is reset.
When this feature is enabled, it provides a convenient reminder to perform
routine maintenance. Refer to the Periodic Maintenance Chart for recommended
service intervals.
Use the following procedure to reset or change the service interval.
1. Press and hold the MODE button to
enter the settings menu.
2. Press either toggle button to cycle to
the "Service Hours" option. Press
MODE to select.
3. Press MODE to reset the existing
value and exit, or press either toggle
button to change the value. Press
MODE to save and exit to the
settings menu.
SPEED LIMITATION DEVICE (IF EQUIPPED)
1. Press and hold the Mode button to
enter the settings menu.
2. Use the toggle buttons to find the
Speed Limitation screen (SPD LIM).
Press the MODE button to select.
3. Choose your desired maximum
speed (between 30-85 km/h) by
using the toggle buttons.
The Speed Limitation feature is disabled automatically when the MODE button is
pressed again or ignition switch is in the OFF position.
FEATURES AND CONTROLS
65
Advertisement
Table of Contents
