12. RS-232 Operation
USB Reset Command
The available formula for the USB Reset command is as follows:
Command + Control + [Enter]
For example, to reset the USB connection, type the following:
usbreset on [Enter]
12.4.10 Restore Default Settings
The Restore Default Settings command allows you to reset all of the KVM's settings back to the default.
The default setting is OFF.
Use the Formula → to set Parameters → to create a Command.
Formula
Command + Control + [Enter]
Parameters
Command
reset
Control
on
Enter
Enter
Restore Default Value Command
The available formula for the Restore Default Settings command is as follows:
Command + Control + [Enter]
For example, to restore all KVM settings back to the default, type the following:
reset on [Enter]
12.4.11 Firmware Upgrade
The Firmware Upgrade command allows you to enable the firmware upgrade mode. The default setting is off.
Use the Formula → to set Parameters → to create a Command.
Formula
Command + Control + [Enter]
Parameters
Command
upgrade
Control
on
Enter
Enter
Description
Restore Default Settings command
Description
Enable restore default values
Description
Enter and send out command
Description
Firmware Upgrade command
Description
Enable firmware upgrade mode
Description
Enter and send out command
52