13
Reverse Warning Buzzer (If Equipped)
FUSE REMOVAL
1.
Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline/Diesel Vehicles on
page 1-3.
2.
Remove the electrical component cover (located near the battery) and remove the fuse from the fuse block.
FUSE INSTALLATION
1.
Install the fuse. See following WARNING.
WARNING
• If a fuse is blown, determine the cause of the failure and make necessary repairs before installing a
new fuse. Use the appropriately rated fuse; if a fuse with a higher amp rating is used, damage to the
vehicle electrical system may occur.
2.
Install the electrical component cover.
3.
Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline/Diesel Vehicles, Section
1, Page 1-4.
REVERSE WARNING BUZZER (IF EQUIPPED)
See General Warnings, Section 1, Page 1-2.
TESTING THE REVERSE WARNING BUZZER
See Test Procedure 26 – Reverse Warning Buzzer (If Equipped) on page 11-30.
REVERSE WARNING BUZZER REMOVAL
1.
Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline/Diesel Vehicles on
page 1-3.
2.
Raise the hood.
3.
Remove the plastic rivets securing the reverse warning buzzer and remove the reverse warning buzzer (Figure
13-7, Page 13-13).
Page 13-12
2008-2012 All-Wheel Drive Maintenance and Service Manual
ELECTRICAL COMPONENTS: GASO-
LINE VEHICLES