Fuse; Testing The Fuse; Fuse Removal; Fuse Installation - Club Car Precedent 2014 Maintenance And Service Manual

20

Fuse

FUSE
See General Warnings on page 1-2.

TESTING THE FUSE

See Test Procedure 2 – Fuse on page 19-14.

FUSE REMOVAL

1. Disconnect battery. See Disconnecting the Battery – Gasoline Vehicles on page 1-3.
2. Remove cover from fuse holder.
3. Remove the fuse from the fuse holder.

FUSE INSTALLATION

1. Install the fuse. See following WARNING.
WARNING
• If a fuse is blown, determine the cause of the failure and make necessary repairs before installing a
new fuse. Use the appropriately rated fuse; if a fuse with a higher amp rating is used, damage to the
vehicle electrical system may occur.
2. Install the cover on the fuse holder.
3. Connect battery. See Connecting the Battery – Gasoline Vehicles on page 1-4.

LIMIT SWITCHES

ACCELERATOR PEDAL LIMIT SWITCH

See General Warnings on page 1-2.
Testing the Accelerator Pedal Limit Switch
See Test Procedure 5 – Throttle Position Sensor (TPS) on page 19-17.
The accelerator pedal limit switch is housed inside the throttle position sensor. The throttle position sensor itself is not
intended to be replaced. If sensor is determined to need replacing through test procedures found in this manual, the
accelerator pedal assembly must be replaced.
Page 20-16 2014 Precedent ® Golf Car Maintenance and Service Manual
ELECTRICAL COMPONENTS (GASO-
LINE VEHICLE)