Stand-Alone Node Setup; Software Installation - Alcatel-Lucent 1665 Installation Manual

Stand-alone node setup

........................................................................................................................................................................
Quantity
1
1
1
PC minimum requirements
For PC minimum requirements see

Software installation

Description
Installation of the Alcatel-Lucent 1665 Data Multiplexer Extend (Alcatel-Lucent 1665
DMXtend) WaveStar
Multiplexer Extend (DMXtend) Release 9.1.0 Software Release Description, which is
provided with the software CD. To install the CIT software, please follow the procedures
in the "Installing software and documentation on a PC" section of the CRN.
Software installation
CIT software installation is accomplished by performing the "Installing software and
documentation on a PC" section in the Alcatel-Lucent 1665 Data Multiplexer Extend
(DMXtend) Release 9.1.0 Software Release Description which is shipped with the
software CD. When the software installation is complete, check off the appropriate box in
the "Installation checklist" (p.
........................................................................................................................................................................
5 - 2
Description
CIT Interface Cable
CIT Cross-Over Cable
Software CD-ROM
Software Release Description
(CRN)
LBOs
PC minimum requirements
®
CIT software is covered in detail in the Alcatel-Lucent 1665 Data
II-5).
Comments
8-ft. long RJ45 to 9-pin D-sub serial cable
(Comcode 848748869). Required to
connect the PC to the CIT jack on the
front of the SYSCTL circuit pack.
This cable is used for IAO LAN
(OSI/TCP-IP) Front LAN connection
cross over cable should be used if the shelf
is directly connected to a PC and LAN
10BASE-T straight through cable should
be used if shelf is connected to a hub
Verify latest software version is being
used.
Verify latest the issue of the CRN is being
used, for the software that is used.
15-dB, 10-dB and 5-dB LBOs are required
when looping back the main OLIUs on
themselves.
.
Alcatel-Lucent 1665 DMXtend R10.0
365-372-327R10.0 Issue 1
January 2013