........................................................................................................................................................................

Figure 3-10 10/100BASE-T/TX cable connections

................................................................................................................................................

Route the cables to the left along the backplane and out of the bay to the 110/RJ45 punch

down block. Route the cables in the same manner as DS3/EC1 cables. See

"10/100BASE-T cable routing" (p.

Note:

as viewed from the rear but they will route to the left of the shelf due to the forming of

the connector.

Note:

connectors J2D, J4D, J8G, and J10G difficult, but there are currently no plans to use

these connectors in a 10/100BASE-T application.

Figure 3-11 10/100BASE-T cable routing

................................................................................................................................................

Route the cables along the cable rack and into the terminating bay.

........................................................................................................................................................................

Alcatel-Lucent 1665 DMXtend R10.0

365-372-327R10.0 Issue 1

January 2013

These cables will connect to J1D, J3D, J7G, and J9G on the right of the shelf

In routing to the left side of the shelf these cables will make access to

3-37).

Figure 3-11,

3 - 3 7

Table of Contents