........................................................................................................................................................................

Turn-up and test the LNW785 8-channel OMD

Description

This procedure provides a method to provision and test an optical span using the 8-channel

OMD LNW785 circuit pack. The procedure requires a LNW785 at both ends of the span

and that there is least one OC-192/10Gbps source at each end of the span. The source OC-

192 could be a LNW141, LNW603, LNW705, or an OC-192/10Gbps from a alien shelf

but the source MUST be compatible with the wavelengths on the LNW785. The LNW141

must be equipped with X10G52C5 through X10G59C5. The LNW603 must be equipped

with X10G53C5, X10G56C5, or X10G58C5. If using an alien 10Gbps source, see

Table 8-3, "Channel/port assignments" (p. 8-19)

If the LNW705 is used as the test signal, proceed to

muxponder" (p. 8-6)

................................................................................................................................................

Determine and document the test signal frequency.

................................................................................................................................................

Install the LNW785 into the Alcatel-Lucent 1665 DMXtend shelf by opening both

faceplate latches and seating in the slot while closing the latches.

Note:

to be configured as an add/drop, it is recommended that the Growth slots are not used

because the passthrough fibers would have to route over the SYSCTL. If the Main

slots are not equipped with Very Large Fabric LNW141 or LNW84 OLIU circuit

packs, then the circuit packs in a Function/Growth slot must be the same type.

................................................................................................................................................

Create OCH Cross-connections

Select Configuration > OCH Cross-connections from the System View

................................................................................................................................................

Select the Create a new OCH cross-connection radio button in the OCH Cross-

Connection Wizard. Click Next.

Click the 2-way Add/Drop radio button from the cross-connection list. Click Next.

........................................................................................................................................................................

8 - 4

The LNW785 can be installed in any Function/Growth slot. When the shelf is

for the wavelengths specifications.

"Turn up and test the LNW705

CIT.

Alcatel-Lucent 1665 DMXtend R10.0

365-372-327R10.0 Issue 1

January 2013

Table of Contents