Part I: Physical And Power Installation - Alcatel-Lucent 1665 Installation Manual

Physical and power installation
............................................................................................................................................................................................................................................................
Tools, test equipment and accessories
This section lists the tools, test equipment and accessories needed to perform all the
procedures in this installation manual.
Listed below are the required tools, test equipment and accessories.
Qty.
1
1
2
1
1
1
1
1
............................................................................................................................................................................................................................................................
I- 2
Description
19" Mounting Brackets
849011804
Screwdriver(s)
*
Thomas & Betts R-5648B
Crimping Tool
†
Paladin Coaxial Wire
Stripper R-5648B
†
Replacement Paladin
Cassette R-5648B D5
Wire-Wrap Gun
R-4496A
ESD Wrist Strap
R-4987C
Torque Wrench
R-5952
Metric & Inch Series Tool
Set
R-6001
Multimeter (Optional)
ITE-6379C
Comments
The 19" mounting brackets (C849011804) must be
ordered separately and are required to install the
Alcatel-Lucent 1665 DMXtend in a 19" bayframe.
A screwdriver(s) with the appropriate head(s) is (are)
required for securing the mounting screws,
repositioning the mounting brackets, installing the
interfacing cables, and for setting the circuit breakers
to the OFF position.
The crimping tool and wire stripper are only required
if installing DS3/EC1 cables. The replacement
cassette is for the wire stripper tool.
The wire-wrap gun is required for terminating DS1/E1
cable and must be able to accommodate 24 gauge
wire.
A wrist strap must be worn when handling circuit
packs. Use the electrostatic discharge (ESD) jack
provided on the shelf.
A torque wrench (50-250 IN-LBS) is used when
Alcatel-Lucent 1665 DMXtend
tightening the
to the frame. It is also used when reattaching the
mounting brackets to the
DMXtend
shelf.
Because some of our Optical Networking Products
(also know as Transport) may have some metric
fasteners, please ensure that the proper metric tools are
available.
The voltmeter must be capable of measuring DC
voltage in the 40 to 60 volt range. The use of the
voltmeter is optional since the shelf will alarm or shut
down if the proper voltage is not supplied.
shelf
Alcatel-Lucent 1665
Alcatel-Lucent 1665 DMXtend R10.0
365-372-327R10.0 Issue 1
January 2013