Integrating The Lnw705 Into The Lnw785 - Alcatel-Lucent 1665 Installation Manual

WDMX setup and testing: integration procedures
........................................................................................................................................................................
................................................................................................................................................
23
Check off the appropriate box in
E O
N D
........................................................................................................................................................

Integrating the LNW705 into the LNW785

Description
The output of the LNW705 OTU-2 signal is compatible with the input channels of the
LNW785. The procedure below assumes that
appropriate box in the "Installation checklist" (p. III-4)." (p. 8-6)
Steps
................................................................................................................................................
1
Install the LNW785 into the Alcatel-Lucent 1665 DMXtend shelf by opening both
faceplate latches and seating in the slot while closing the latches.
Note:
to be configured as an add/drop, it is recommended that the Growth slots are not used
because the passthrough fibers would have to route over the SYSCTL. If the Main
slots are not equipped with VLF mains (LNW59, LNW82, LNW504), then the circuit
packs in a Function/Growth slot must be the same type.
................................................................................................................................................
2
Login to the Alcatel-Lucent 1665 DMXtend using the WaveStar
................................................................................................................................................
3
Create OCH Cross-connections
Select Configuration > OCH Cross-connections from the System View
................................................................................................................................................
4
Select the Create a new OCH cross-connection radio button in the OCH Cross-
Connection Wizard. Click Next.
................................................................................................................................................
5
Click the 2-way Add/Drop radio button from the cross-connection list. Click Next.
........................................................................................................................................................................
Alcatel-Lucent 1665 DMXtend R10.0
365-372-327R10.0 Issue 1
January 2013
S
F T E P S
The LNW785 can be installed in any Function/Growth slot. When the shelf is
Table I-2, Installation
Step 1 through
checklist.
Step 16 in "Check off the
have been completed.
®
CIT.
8 - 9