Alcatel-Lucent 1665 Installation Manual page 116

Cable and fiber installation
........................................................................................................................................................................
Sync cable with wire-wrap DB-9 connector procedure
Perform the following steps when using the Sync cable with the wire-wrap DB-9
connector.
................................................................................................................................................
1
Connect the wire-wrap DB-9 connector to SYNC1 (J11). See
connections" (p.
................................................................................................................................................
2
Wire-wrap Rx1 and Tx1 (red cable) on the D-Sub connector for an output signal per
Table 3-19, "Synchronization cable (DS1 timing reference) connections" (p.
................................................................................................................................................
3
Wire-wrap Rx2 and Tx2 (gray cable) on the D-Sub connector for an input signal per
Table 3-19, "Synchronization cable (DS1 timing reference) connections" (p. 3-50)
................................................................................................................................................
4
Route the cable to proper location and cut to desire length.
................................................................................................................................................
5
Terminate the other end to a clock source or equipment. See
cable (DS1 timing reference) connections" (p. 3-50)
................................................................................................................................................
6
Repeat
................................................................................................................................................
7
Check off the appropriate box in the
E O
N D
........................................................................................................................................................
........................................................................................................................................................................
3 - 4 8
3-47).
Step 1 through Step 5
S
F T E P S
for SYNC2 (J12) connection.
Table I-2, Installation
Figure 3-14, "Sync cable
Table 3-19, "Synchronization
for connection information.
checklist.
Alcatel-Lucent 1665 DMXtend R10.0
365-372-327R10.0 Issue 1
3-50).
January 2013