Lbo Software Settings - Alcatel-Lucent 1665 Installation Manual

Stand-alone installation testing
............................................................................................................................................................................................................................................................
Quantity
1
1
1
1
PC minimum requirements
For PC minimum requirements see

LBO software settings

Description
This section provides instructions for setting the software Line Build Out (LBO) for the
DS1/E1 and DS3/EC1 cabling. The SYSCTL, DS1/E1 and/or DS3/EC1 circuit packs must
be installed and software must be loaded.
Follow this procedure to set the LBOs for the DS1/E1, DS1/DS3/16/3, DS3/EC1, and
TMUX circuit packs.
............................................................................................................................................................................................................................................................
6 - 4
Description
Personal Computer (PC)
CIT Interface Cable
CIT Cross-Over Cable
Software CD-ROM
Software Release Description
(CRN)
LBOs
PC minimum requirements
Comments
Required to run the WaveStar
software.
8-ft. long RJ45 to 9-pin D-sub serial cable
(Comcode 848748869). Required to
connect the PC to the CIT jack on the
front of the SYSCTL circuit pack.
This cable is used for IAO LAN
(OSI/TCP-IP) Front LAN connection
cross over cable should be used if the shelf
is directly connected to a PC and LAN
10BASE-T straight through cable should
be used if shelf is connected to a hub
Verify latest software version is being
used.
Verify latest the issue of the CRN is being
used, for the software that is used.
15-dB, 10-dB and 5-dB LBOs are required
when looping back the main OLIUs on
themselves.
.
Alcatel-Lucent 1665 DMXtend R10.0
®
CIT
365-372-327R10.0 Issue 1
January 2013