............................................................................................................................................................................................................................................................

New installation

The procedure below describes how to remove the center dividers for new installations.

Steps

The figure below shows the new Alcatel-Lucent 1665 DMXtend shelf with the center

dividers inserted.

Note:

shown in

Remove this spring clip by inserting a finger into the hole and pulling gently away

from the shelf. Keep this spring clip available if there is ever a need to reinstall the

center divider for the use of half-width cards in the shelf.

Figure 2-3 Center divider

To remove the top center divider, depress the spring clip latch located on top of the divider

and slide the divider out.

Remove the bottom center divider by depressing the bottom spring clip and sliding the

divider out.

N D

........................................................................................................................................................

Existing installation

This procedure is used to remove the center dividers if circuit packs are installed above or

below the dividers and the spring clip is not accessable.

2 - 6

The center dividers come equipped with a spring clip CC849027222 not

Figure 2-3, "Center divider" (p. 2-6)

Center

Divider

T E P S

that latches the dividers together.

Spring

clip