Alcatel-Lucent 1665 Installation Manual page 202

Stand-alone installation testing
............................................................................................................................................................................................................................................................
Result:
parameter). A port state of "IS" indicates that the pack is receiving a good signal to the
port
........................................................................................................................................................................................................................
12
While observing the error-free transmission, grasp the DS3 cable about two inches from
the BNC connector head and gently rotate (twist) the cable in a clockwise and counter-
clockwise direction about 45 degrees (gently).
Result:
connector must be cut off and replaced.
If an error free signal is not received:
Check the LBOs settings using the View:Equipment command (see
•
LBOs" (p.
Verify that the pack is provisioned for the framing format being sent from the test set,
•
CBIT or M13.
Verify that the port is provisioned for DS3.
•
Check the DS3/EC1 cabling for proper connections.
•
........................................................................................................................................................................................................................
13
Use the GUI command to delete the cross-connect.
........................................................................................................................................................................................................................
14
Click Configuration:Cross-Connections.
........................................................................................................................................................................................................................
15
Select Delete legs of an Existing cross-connection.
........................................................................................................................................................................................................................
16
Select Next.
........................................................................................................................................................................................................................
17
Click on the
........................................................................................................................................................................................................................
18
Double click on port 1 (OC-N).
........................................................................................................................................................................................................................
19
Select Next.
............................................................................................................................................................................................................................................................
6 - 1 8
The DS3 provisioning will be displayed, along with the port state (last
If any errors are detected while performing this "wiggle test", the BNC
6-5).
main (OC-N).
"Setting DS1/E1
Alcatel-Lucent 1665 DMXtend R10.0
365-372-327R10.0 Issue 1
January 2013