Alcatel-Lucent 1665 Installation Manual page 276

WDMX setup and testing: integration procedures
........................................................................................................................................................................
................................................................................................................................................
14
Inject a single error from the test set.
Result:
................................................................................................................................................
15
Repeat
................................................................................................................................................
16
Remove fiber and LBOs from Port 9 of both LNW705s.
................................................................................................................................................
17
Establish the end to end link on the 10G PTM while observing the proper optical levels
listed in
to "Integrating the LNW705 into the LNW785" (p.
................................................................................................................................................
18
Locate and connect the span fibers to the LNW705 while observing the proper optical
levels listed in
................................................................................................................................................
19
Repeat
................................................................................................................................................
20
Observe test set and verify error-free transmission. If only one test set is available, connect
a fiber from the In port to the Out port of the PTM in port 1 at one end. Use the
information listed in
LBO/Attenuator.
Note:
customer.
................................................................................................................................................
21
Disconnect test set(s) and fiber jumper from ports.
................................................................................................................................................
22
Remove PTM from LNW705 if necessary and clear any associated alarms by selecting
Configuration > Update System> Update Inventory.
........................................................................................................................................................................
8 - 8
Test set reports the error.
Step 1 to Step 14 at the other node.
Table 8-4, "Attenuation Table" (p.
Table 8-4, "Attenuation Table" (p.
Step 18 at the LNW705 at the other node on the opposite end of the span.
Table 8-4, "Attenuation Table" (p. 8-19)
Test duration may be determined by engineering specification or by the end
8-19). If connecting through the LNW785 go
8-9), otherwise continue.
8-19).
to determine the proper
Alcatel-Lucent 1665 DMXtend R10.0
365-372-327R10.0 Issue 1
January 2013