Fiber Connections; Lbos Based On Attenuation - Alcatel-Lucent 1665 Installation Manual

Installing fiber connectors and LBOs
............................................................................................................................................................................................................................................................
Table C-3 LBOs based on attenuation

Fiber connections

General
Alcatel-Lucent 1665 DMXtend uses AllWave ADVANTAGE™ Lightguide Jumpers, part of
Alcatel-Lucent's AllWave ADVANTAGE™ Optical Connectivity Solution (OCS). These
jumpers contain a boot angled at 40 degrees, allowing the jumpers to dress appropriately
into the fiber tray. The angled boot eliminates projection outside the front of the shelf
assembly.
All fiber connectors should be cleaned and inspected before assembling into connector
ports. See
connectors when not installed in a connector port.
LC-type connections
LC-type fiber connectors use a snap-action, lever-tab locking method to join the fiber
connector to the port connector.
............................................................................................................................................................................................................................................................
Alcatel-Lucent 1665 DMXtend R10.0
365-372-327R10.0 Issue 1
January 2013
PTM optics Circuit Pack
*
X10GxxC5 LNW141, LNW705
series
Notes:
* LNW705 only uses X10G31C5-X10G49C5
Code
ABLCS-05.0
ABLCS-10.0
ABLCS-15.0
ABLCS-20.0
Appendix A, "Fiber
Comcode
108279381
108279431
108279480
108279530
cleaning". Dust caps should be applied to all fiber
Received LBO
Power (dBM) (dB)
-8.0 to -24 15
Loss (dB)
5
10
15
20
C - 7