Use Of Wavestar ® Cit Software - Alcatel-Lucent 1665 Installation Manual

Stand-alone node setup
........................................................................................................................................................................
................................................................................................................................................
9
If there are any FAULT LEDs on or flashing on any of the inserted circuit packs; press the
UPD/INIT pushbutton on the SYSCTL circuit pack.
Result:
update the system and should clear any flashing FAULT LEDs on any of the low speed
circuit packs.
................................................................................................................................................
10
If FAULT LEDs remain lit on any of the inserted circuit packs, replace the respective
circuit pack.
................................................................................................................................................
11
Any other alarms will be cleared later on in
"Clearing alarms" (p.
................................................................................................................................................
12
Check off the appropriate box in the
E O
N D
........................................................................................................................................................
Use of WaveStar
Description
Complete the following steps to login to the Alcatel-Lucent 1665 DMXtend via
WaveStar
LNW2 system controller is installed and operational to the Alcatel-Lucent 1665 DMXtend
shelf per the Alcatel-Lucent 1665 Data Multiplexer Extend (DMXtend) Release 9.1.0
Software Release Description.
Steps
................................................................................................................................................
1
Connect the PC serial port to the RS-232 port of the SYSCTL circuit pack with a serial
RS-232 cable
to the front LAN port of the SYSCTL circuit pack with a RJ45 to RJ45 cross-over cable
Table 3-15, "LAN 10Base-T straight-through cable connections" (p.
Note:
Otherwise, you may experience login problems. To assign an IP address, start the DOS
........................................................................................................................................................................
5 - 6
The operation of the UPD/INIT pushbutton on the SYSCTL circuit pack will
6-7).
S
F T E P S
®
CIT software
®
CIT. It is assumed that the CIT software has been installed on the PC and the
[Table 3-24, "CIT Cable Assembly" (p.
An IP address must be assigned to the NIC card on the PC or laptop.
Chapter 6, "Stand-alone installation
"Installation checklist" (p.
3-64)]. Or connect the PC LAN port
testing",
II-5).
3-44).
Alcatel-Lucent 1665 DMXtend R10.0
365-372-327R10.0 Issue 1
January 2013