Alcatel-Lucent 1665 Installation Manual page 158

Circuit pack installation
............................................................................................................................................................................................................................................................
Note:
The LNW170 circuit packs support both electrical and optical PTMs for both GbE and
FE. When inserting them into ports, provision the card appropriately. This procedure
consists of two parts. Installing the circuit card and installing the PTM per
B, Install pluggable modules (p.
........................................................................................................................................................................................................................
1
See the engineering job specification. Identify the proper function group slot (D-G) where
the LNW170 circuit pack will be installed.
........................................................................................................................................................................................................................
2
Remove the LNW170 from the packing material.
........................................................................................................................................................................................................................
3
Place the circuit pack into the shelf (slot D1 or G1 as required). Do NOT engage the
circuit pack in the backplane connector.
........................................................................................................................................................................................................................
4
If slot 2 is empty, install a 177D or LNW98 Apparatus Blank into the companion circuit
pack slot.
Important!
to provide proper air flow for cooling.
........................................................................................................................................................................................................................
5
Repeat
LNW170 circuit packs.
........................................................................................................................................................................................................................
6
Install the PTM module per
........................................................................................................................................................................................................................
7
Check off the appropriate box in the
E O
N D
........................................................................................................................................................
LNW402 OC48 1310 nm, 1550 nm, or DWDM PTM Optics
Follow this procedure to install the LNW402 circuit packs in the Alcatel-Lucent 1665
DMXtend shelf. The high-speed LNW402 is a single-port OLIU that employs PTM
pluggable optics to offer 1310 nm, 1550 nm, or DWDM optics with a 12 STS-1 VT fabric.
The LNW402 circuit pack and three of the supported OC-48 PTMs are approved for OSP
deployments.
............................................................................................................................................................................................................................................................
4 - 2 4
The LNW170 circuit packs require PTM modules for the Ethernet interface.
177D or LNW98 Apparatus Blanks are required in all unused slots D and G
Step 1 through Step 4
Appendix
S
F T E P S
B-8).
for each additional function group to be equipped with
B, Install pluggable modules (p.
"Installation checklist" (p.
Appendix
B-8).
I-6).
Alcatel-Lucent 1665 DMXtend R10.0
365-372-327R10.0 Issue 1
January 2013