Oc-192 Low-Speed Testing - Alcatel-Lucent 1665 Installation Manual

Stand-alone installation testing
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
12
Replace all protective dust covers on the LNW62, LNW55, LNW402 PTM OC-48 OLIU
connectors (OLIU and LGX), that were removed to perform this procedure.
........................................................................................................................................................................................................................
13
Check off the appropriate box in the
E O
N D
........................................................................................................................................................

OC-192 low-speed testing

OC-192 low-speed testing procedure
Perform the following steps for all Alcatel-Lucent 1665 DMXtend shelf Function unit or
Growth slots containing OC-192 (LNW603) OLIU.
Note:
on the OLIU, make the connections at the LGX equipment in order to verify correct
installation and labeling of the fibers.
LBOs are installed on the OLIU faceplate IN port.
........................................................................................................................................................................................................................
1
Identify the function groups that contain an OC-192 OLIU circuit pack and fully insert the
OLIU into the shelf.
Requirement:
OLIU.
............................................................................................................................................................................................................................................................
6 - 3 6
S
F T E P S
NOTICE
Laser Safety
When connecting fiber loops between the IN and OUT ports on optical circuit
packs, always connect to the IN port first and then the OUT port. This will
prevent any optical radiation from being present at the fiber end.For more
detailed information and safety precautions, see
When reference is made to optical fiber loopback connections to IN and OUT
After a few moments, the ACTIVE LED should be lit on the OC-192
"Installation checklist" (p.
Chapter 1,
II-5).
"Safety".
Alcatel-Lucent 1665 DMXtend R10.0
365-372-327R10.0 Issue 1
January 2013