Placing The Labeling System; Setting Up The Labeling System - Weber Geset 111 Original User Manual

Chapter 6 Installation and initial startup

Placing the labeling system


The labeling station has to be adapted to the customer's conveying system in
position and height. The height of the system parts has to be ergonomically
designed according to the user's requirements.

The installed position must allow sufficient access for users and service
technicians. In particular at all times, the mains switch / plug must be freely
accessible to disconnect the power supply

Make sure that all fasteners are sufficiently tight.

Observe all of the items under "Intended use" in the chapter "Safety regulations".

Setting up the labeling system

Requirements

The labeling system is unpacked and prepared (see the chapter: "Transport" on
page 24) near the labeling site in the area of the installation site.

The base is solid, level and flat.

The labeling system and if applicable the turning plate must be completely installed.

The connections for the compressed air and electricity are close to the labeling site
(maximum distance of 1.5 m) as specified in the chapter: "Specifications" on page
21).
Required equipment

Flat wrench

Spirit level

If applicable 2-3 persons
Instruction
Set a labeling system up as follows.
Step
1
2
Version: 12.05.14
Procedure
Move the labeling system to installation site. Move labelers without rolls
piece by piece diagonally. Consider all points for "Placing the labeling
system" on page 29.
Adjust the labeling system with an air lever by the adjustable feet
horizontally. (With rolls, the brakes have to be locked). See also "Adjust
base conveyor".
Page 29 of 56
40001684 Geset 111
GB