Cancelling A Rebuild And Restarting It With A Different Drive; Setting Background Task Rate - 3Ware 9550SXU-12 User Manual

Maintaining Units
Cancelling a Rebuild and Restarting It with a
Different Drive

Setting Background Task Rate

172
When you start a rebuild from 3BM, you cannot cancel it in 3BM interface.
However, if you have drives in hot swap bays, you can remove and replace the
drive, rescan the controller (Alt-R), and then select a new drive to be used in
the rebuild. You can also boot the operating system, launch 3DM, and cancel a
rebuild by using the
Remove Drive
If your drives are not in hot swap bays and you do not want to boot the
operating system and launch 3DM, you can also cancel a rebuild by powering
down the system, physically removing a drive, and installing another one that
you want to use. Then when you start 3BM, the unit will appear as degraded
and you can rebuild it, using the steps described under "Rebuilding Units
through 3BM" on page 169.
Note:
If you want to pause the rebuild process through 3DM, you can do so by
setting or changing the rebuild schedule on the Scheduling page. If you set a
schedule for rebuilds that does not include the current time, the rebuild process will
pause.
In 3DM, you can set the relative performance of background tasks
(initializing, rebuilding/migrating, and verifying) in relation to normal I/O
activity (reading and writing to disk).
Controllers can have separate settings for Rebuild/Migrate Rate and Verify
Rate. (Initialization occurs at the Rebuild rate.)
To change the background task rate
1 Choose Management > Controller Settings
2 In the Background Task Rate
select one of the five radio buttons to indicate the relative task rate for
Rebuild and Verify Tasks.
The furthest left buttons set the firmware to the fastest rebuild and verify
settings. This means that maximum processing time will be given to
rebuilds or verifies rather than I/O. The furthest right buttons set the
firmware to the slowest rebuild and verify settings, giving maximum
processing time to I/O.
After you select one of the radio buttons, the page refreshes, and a
message at the top confirms the change you have made.
3ware SAS/SATA RAID Software User Guide, Version 9.5.1
link on the Maintenance page.
from the menu bar.
section of the Controller Settings page,