Updating The 3Ware Driver Under Suse - 3Ware 9550SXU-12 User Manual

Updating the 3ware Driver Under SuSE

www.3ware.com
For Red Hat Hugemem
mkinitrd –v –f initrd-
string> hugmem
7 If you are using lilo, run lilo to update to the boot loader.
You should see a printout of kernels that are able to boot on this system
after running lilo.
The following steps describe how to update the 3ware driver under SuSE.
Note:
Pre-compiled, tested, and supported drivers are no longer available for older
SuSE Linux releases using the 2.4 kernel. The source code is still available (for a
limited time) if a newer 2.4 driver is still needed. Check the release notes for more
details regarding supported operating systems.
Backup your original driver before updating in case you need to revert back to it.
However, you will not be able to revert back to the original driver if you are booted
from that unit.
To update the 3ware driver under SuSE
1 Download and extract the driver, as described under "Downloading the
Driver and Firmware" on page 181.
2 Backup any critical data prior to updating the 3ware driver.
3 Change the directory to the location with the extracted driver.
4 Copy the files to the appropriate directory.
(In the commands below, replace <version> with applicable SuSE
version, such as su10)
Replace <kernel string> with applicable kernel (i.e.: 2.6.16.x)
For SuSE Uniprocessor (2.6 kernels)
cp <version> /3w-9xxx.ko /lib/modules/
drivers/scsi/3w-9xxx.ko
For SuSE SMP (2.6 kernels)
cp <version> /3w-9xxx.smp /lib/modules/
drivers/scsi/3w-9xxx.ko
For SuSE high memory systems (2.6 kernels)
cp <version>/3w-9xxx.big /lib/modules/<kernel string>/
kernel/drivers/scsi/3w-9xxx.ko
Updating the Firmware and Driver
<kernel string> hugmem.img
<kernel string>
<kernel string>
<kernel
/kernel/
/kernel/
197