Problems In 3Dm And 3Bm - 3Ware 9550SXU-12 User Manual

Problems in 3DM and 3BM

www.3ware.com
A unit shows up as unusable, because of missing drives:
Unusable Arrays:
3 drive 64K RAID 5 558.77 GB (Unit 1)
SATA - Maxtor
The unit has some but not all of its members available. The
unit will be unusable. If this unit is your boot device, your
system will not boot. You must either return the missing
disks to complete the unit, or release the member disks by
deleting the incomplete unit(s) listed in the display.
Remember that deleting a RAID unit overwrites any existing
data on the member drives.
Do not delete the inoperable unit and recreate it, as this will
CAUTION:
overwrite the data and make data recovery very difficult.
If you get this error, contact technical support at
support/.
A 3ware RAID controller does not show in the list of controllers
You may not the most recent driver for your controller, the driver may not be
loaded, or you may not have the most recent version of the CLI or 3DM.
To find out the driver version currently installed, see "Determining the
Current Version of Your 3ware Driver" on page 179
Current drivers and software are available for download on the 3ware website
at
http://www.3ware.com/support/download.asp.
When booting a system, a drive is not showing up in the startup
screens, in 3BM, or in 3DM
This could be due to one or more of the following:
• Defective cable
• Defective drive
• Defective RAID cage/chassis slot
• Poorly seated drive
• Poorly connected power cable
• Poorly connected data cable
• Defective connector on the 3ware controller
6B300S0 279.86 GB
http://www.3ware.com/
Problems and Solutions
(Port 6)
257