3Ware 9550SXU-12 User Manual page 213

www.3ware.com
To compile the driver as a module
1 Boot to FreeBSD.
2 Download and extract the driver, as described under "Downloading the
Driver and Firmware" on page 181.
twa.tgz. Then copy the *.c
3 Unpack
/sys/dev/twa and the Makefile
twa.ko
4 Build the module
cd /sys/modules/twa
make
twa.ko
The module is created in
To load the driver as a module
1 In the current configuration file under
/usr/src/sys/amd64/conf
3ware 9000 series
the kernel.
2 Rebuild the kernel.
config
Run command
file: (GENERIC, SMP, PAE, or your custom config), followed by:
cd ../compile/<
make clean
make cleandepend
make depend
make
make install
3 Reboot to FreeBSD.
4 Load the kernel driver module from
cd /sys/modules/twa
kldload ./twa.ko
5 If you wish to load the driver automatically every time the system is
rebooted, add the line
/boot/loader.conf
Updating the Firmware and Driver
and
/sys/modules/twa
to
/sys/modules/twa
/usr/src/sys/i386/conf
comment out the entry: "
". This will unlink the old driver once you rebuild
<config_name> specifying your configuration
config_name >
/sys/modules/twa
twa_load="YES"
' ' to the file
*.h
files to
.
or
Device twa #
201