3Ware 9550SXU-12 User Manual page 92

3DM 2 (3ware Disk Manager) Introduction
80
Table 8: List of 3DM Pages
3DM Page Description
Controller Phy Shows the properties of controller phys for 9690SA RAID
Summary page controllers.
There are two ways to access this page. If you have a direct-
attached drive you can access this page from the Information
> Drive Information page by clicking the phy ID for the drive.
If all drives are connected via expanders, navigate to the
Management > Controller Settings page. Under Other
Controller Settings click the # link for Number of Controller
Phys.
Controller Lets you view settings that affect the units on the current
Settings page controller and change some of those settings.
Controller-level settings that can be changed include
background task rate, Auto Rebuild, Auto-Carving, and Carve
Size. Some additional policies are shown that can only be
changed in the BIOS or CLI.
Unit-level settings include specifying the StorSave Profile and
enabling or disabling the Write Cache, Auto-Verify, Overwrite
ECC, Queuing, and Rapid RAID Recovery.
To see this page, choose Management > Controller
Settings from the menu bar.
Scheduling page Lets you view and change the schedule for tasks that affect all
units on the current controller.
To see this page, choose Management > Scheduling from
the menu bar.
Maintenance Lets you configure new units and make changes to existing
page units.
To view this page, choose Management > Maintenance from
the menu bar.
Alarms page Shows a list of alarms, including the specific alarm message,
and the exact date and time it occurred.
To view this page, choose Monitor > Alarms on the menu
bar.
Battery Backup Shows the status of a Battery Backup Unit (BBU), if one is
page installed, and allows you to test the battery.
To view this page, choose Monitor > Battery Backup on the
menu bar.
Enclosure Lists the installed and supported enclosures attached to your
Summary page 3ware controller.
To view this page, choose Monitor > Enclosure Support on
the menu bar.
3ware SAS/SATA RAID Software User Guide, Version 9.5.1