Setting The Storsave Profile For A Unit - 3Ware 9550SXU-12 User Manual

Setting the StorSave Profile for a Unit

www.3ware.com
Note:
Not all drives support command queuing. If a drive does not support
command queuing, the policy setting for the controller is ignored. Queuing
information for SAS is not available.
To enable or disable queuing for a unit through 3DM
1 Choose Management > Controller Settings
2 In the Unit Policies
queuing by checking the box under "Queuing" for the designated unit;
disable it by unchecking the box.
The page refreshes, and a message at the top confirms the change that you
have made.
To enable or disable queuing for a unit through 3BM
1 At the main 3BM screen, select the unit by highlighting it and pressing
An asterisk appears in the left-most column to indicate that it is selected.
2 Tab to the
Maintain Unit
3 On the pop-up menu, select
4 In the
Configure Disk Array
Mode .
5 Press Enter to display the choices, use the
you want (Enabled or Disabled), and press
6 to the button and press
Tab OK
You return to the main 3BM screen.
7 When you are finished making changes, press
3BM.
You can set the desired level of data protection versus performance for a unit
by selecting the StorSave Profile. Three profiles are provided: Protection
(maximum data protection), Performance (maximum performance, less data
protection), and Balanced (a middle ground). The default is Protection.
section of the Controller Settings page, enable
button and press
Enter
and press
Configure
screen, to the field
Tab
arrow keys
Enter
to select it.
Enter
Setting Unit Policies
from the menu bar in 3DM.
Enter
.
.
Enter
Drive Queuing
to select the setting
again to choose it.
to save them and exit
F8
.
123