3Ware 9550SXU-12 User Manual page 139

www.3ware.com
• Units with Rapid RAID Recovery enabled will not be readable if moved
to controllers using pre-9.5.1 firmware. If you wish to move the unit to a
controller with pre-9.5.1 firmware, you must first disable Rapid RAID
Recovery.
• Units created on controllers with pre-9.5.1 firmware will not be able to
take advantage of Rapid RAID Recovery when the controller is updated
to 9.5.1 or later. These units will show Rapid RAID Recovery as disabled.
Changing or disabling Rapid RAID Recovery
Rapid RAID Recovery can only be enabled (that is - set to All or Rebuild)
when the unit is created. You can change between All and Rebuild at any
time. However, if you disable Rapid RAID Recovery, you cannot then enable
it.
To change or disable Rapid RAID Recovery for an existing unit
through 3DM
1 Choose
Management > Controller Settings
2 In the
Unit Policies
or
Rebuild, Disable
3 Click OK when 3DM asks you to confirm your selection.
The page refreshes, and a message at the top confirms the change that you
have made.
To change or disable Rapid RAID Recovery for an existing unit
through 3BM
1 At the main 3BM screen, select the unit by highlighting it and pressing
.
Enter
An asterisk appears in the left-most column to indicate that it is selected.
2 Tab to the
Maintain Unit
3 On the pop-up menu, select
4 In the Configure Disk Array
and select
Recovery
A warning message appears, asking you to confirm your selection.
5 Type 'Y'.
6 Make any other unit configuration changes you wish to implement and
press .
Enter
section of the Controller Settings page, select
from the Rapid RAID Recovery dropdown menu.
button and press
Enter
and press
Configure
screen, Tab to the field
Fast Rebuild/Shutdown
Setting Unit Policies
from the menu bar in 3DM.
All
.
.
Enter
Rapid RAID
, or .
Rebuild, Disable
,
127