Setting the Sync Rate
Procedure
1. Access the WAN 1 or WAN 2 Sync_Setup Menu using the following path;
Path: Remote or Gateway->Configuration->WAN 1 or 2->Sync_Setup
The following menu appears.
2. Press the
key to the Sync Rate parameter and type in the correct Sync rate. This parameter sets
the synchronous data transfer speed of the WAN port and must match the network device speed.
Note: This Sync Rate information, displayed in bytes, must be obtained through the network device
documentation.
3. Press the
key to accept changes and go back to the Configuration Menu.
4. Press the
key to the Save parameter.
5. Press Enter to save changes to the active config (.rem) file.
EXTender 6000 Quick Installation Guide
Figure 10:
Sync Rate
22