Mitsubishi Eclipse 1990 Service Manual page 29

GENERAL
Special Handling Instructions for
TSB Revision
W H E E L B A L A N C E
FRONT WHEEL MEASUREMENTS
1. Jack up the rear wheels, and place an axle
the designated part of the side sill.
2. Jack up the front wheels and set, a pick-up stand and
balancing machine in place.
Caution
1. Set so that the front and rear of the vehicle are
at the same height.
2. Release the parking brake.
3. Rotate each wheel manually and check to be sure
that there is no dragging.
3. Use the engine to drive the tyres, and then make the
measurement.
Caution
1. If an error is indicated in the state of engine drive,
motor drive can be used concurrently.
2. Do not operate the clutch suddenly, or increase
or reduce speed suddenly during the work.
REAR WHEEL MEASUREMENTS
1. Jack up the front wheels, and 'place an, 'axle stand at
the designated part of the side sill.'
2. Jack up the rear wheels, and then,
stand and balancing machine in place, follow the same
procedure as for front wheel measurements.
Models
,
at
setting a pick-up