Crankshaft Rear Oil Seal - Mitsubishi 3000GT Service Manual

CRANKSHAFT REAR OIL SEAL

REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
Transaxle Assembly Removal and Installation
l
Clutch Cover and Clutch Disc Removal and Installa-
l
tion
Removal steps
1. Flywheel
Camshaft
ENGINE - Crankshaft Rear Oil Seal
73-77 Nm
R E M O V A L S E R V I C E
Stop the crankshaft pulley from turning, and remove the fly-
wheel.
Caution
Use only the specified special tools, otherwise the crank-
shaft pulley damper could be damaged.
(1) Make a notch in the lip section of the oil seal with a
k n i f e , e t c .
(2) Cover the end of (-) screwdriver with a rag, and insert
into the notched section of the oil seal, and lever out
the oil seal to remove it.
Caution
Be careful not to damage the crankshaft and the oil
seal case.
TSB Revision
P O I N T S