Channel Label - Rigol MS05000-4CH User Manual

RIGOL

Channel Label

The instrument uses the channel number to mark the corresponding channel by
default. For ease of use, you can also set a label for each channel. For example,
" ".
Press 1  More  Label to enter the label setting menu. You can use the built-in
label or manually input a label. Three input methods are available for you to input a
label name, including Chinese, English, and Traditional Chinese.
The label setting menu includes the following menu items.
 Press Display to turn on or off the display of the channel label. If it is enabled,
the label will be displayed at the left side of the waveform. When on, CH1 is, by
default, displayed to be the channel label.
 Press Library to select the preset labels such as CH1, ACK, ADDR, BIT, CLK, CS,
DATA, IN, MISO, MOSI, OUT, RX and TX.
 Press Label and the label editing interface is automatically displayed as shown in
Figure 2-3. You can input the label manually. For the label input method, refer to
"To Create a Folder".
Upper-lower
Case Switch
For example, set the label to "
knob to select "Caps" and press down the knob to switch the uppercase or
lowercase mode. Rotate the multifunction knob and select "C", press down the knob.
Then, in the input selection area, rotate the multifunction knob and select "C". Press
down the knob to input "C". Use the same method to input "hn1". After finishing the
input, press OK to finish the editing. You can also enable the touch screen to operate
by touch gestures. If Display is enabled, the label
of CH1 waveform.
To delete or modify the input characters, rotate the multifunction knob
2-10
nd Quality Products Online at:
Label Input Area Input Selection Area Virtual Keypad
Figure 2-3 Label Editing Interface
GlobalTestSupply
www.
Chapter 2 To Set the Vertical System
". In the virtual keypad, rotate the multifunction
Delete Key
will be displayed at the left
or enable
MSO5000 User's Guide
.com
sales@GlobalTestSupply.co