Reference Waveform; To Enable Ref Function; To Set The Reference Waveform; Figure 12.1 Reference Waveform Menu - Rigol HDO1000 Series User Manual

12

Reference Waveform

This series oscilloscope provides 10 reference waveform positions (Ref1~Ref10). In
the actual test process, you can compare the signal waveform with the reference
waveform to locate the failure.
12.1

To Enable Ref Function

You can enter the Ref menu in the following ways.
• Click or tap the function navigation icon
screen, and then select Ref to enter the reference waveform function menu.
• Press the front-panel
When the Ref function is enabled, you can select different colors for reference
waveforms, set the source of each reference channel, adjust the vertical scale and
offset of the reference waveform, save the reference waveform to the internal or
external memory, and recall it when necessary.
12.2

To Set the Reference Waveform

In the Ref menu, you can specify a channel to serve as the reference channel. You can
save or clear the reference channel.
To Select the Reference Channel
Click or tap the drop-down button of Current to select the reference waveform
channel (Ref1-Ref10). By default, Ref1 is enabled.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
key to enter the reference waveform function menu.

Figure 12.1 Reference Waveform Menu

Reference Waveform
at the lower-left corner of the
HDO1000 User Guide
163