ABB IRC5 Compact Product Manual page 85

Stop with RAPID instructions
There are several RAPID instructions available that stops the robot.
Instruction
SystemStopAction
Stop
StopMove
BREAK
EXIT
EXITCYCLE
Product manual - IRC5 Compact
3HAC047138-001 Revision: M
Description
Stops all robots in all tasks imme-
diately.
The current move instruction will
be finished before the robot stops.
A restart will continue the program
execution.
The current move instruction will
be stopped immediately as a nor-
mal program stop but the program
execution will continue with the
next instruction. StartMove must
be executed to get the robot mov-
ing again.
The current move instruction and
the program execution will be
stopped immediately as a normal
program stop. A restart will contin-
ue the program execution.
The current move instruction and
the program execution will be
stopped immediately as a normal
program stop. After stop the Pro-
gram Pointer is lost and has to be
reset to Main.
The current move instruction and
program execution will be stopped
immediately. The Program Pointer
will be moved to Main and if run-
ning mode is continuous, the pro-
gram will be restarted.
© Copyright 2009-2020 ABB. All rights reserved.
2 Installation and commissioning
2.6.9 Programmable stop functions
Arguments
\Stop: similar to a normal pro-
gram stop with stop button.
\StopBlock: as above, but to re-
start the PP has to be moved.
\Halt: this is like a category 0
stop, i.e. it will result in motors off
state, stop of program execution
and robot movements in all motion
tasks. The Motors on button must
be pressed before the program
execution can be restarted.
\NoRegain: the robot will not re-
turn to the stop point when restar-
ted, e.g. after having been jogged
away.
\AllMoveTasks: all robots will be
stopped.
\Quick: the stop will be a soft
stop on path, as described for
system input SoftStop, otherwise
similar to a normal program stop.
\AllMotionTasks: all robots will
be stopped.
Continues on next page
Continued
85