ABB IRC5 Compact Product Manual page 181

Equipment
Connected Services box
Standard toolkit
Other tools and procedures may be required.
See references to these procedures in the
step-by-step instructions below.
Circuit diagram
Removing DSQC 680
Use this procedure to remove the Connected Services box, version DSQC 680.
1
2
3
4
5
6
Product manual - IRC5 Compact
3HAC047138-001 Revision: M
Action
DANGER
Before any work inside the cabinet, read the safety
information in section Electrical safety on page
ELECTROSTATIC DISCHARGE (ESD)
The unit is sensitive to ESD. Before handling the
unit read the safety information in section
is sensitive to ESD on page
On the cabinet front, disconnect the connectors
from the Connected Services contacts.
If you have an Ethernet switch, disconnect the
connectors from this as well.
Remove the cover of the cabinet.
Disconnect all connectors from the safety board,
Connected Services box, and Ethernet switch.
Remove the two attachment screws, and push the
safety board unit backwards to release the latches.
© Copyright 2009-2020 ABB. All rights reserved.
4.17 Replacement of Connected Services box
Information
DSQC 680 or DSQC1016/1023
See Controller system parts on page
The content is described in section
toolkit, IRC5 on page
See Circuit diagrams on page
Information
32.
The unit
49.
xx1400002787
See
controller on page
xx1400001462
4 Repair
Continued
211.
Standard
209.
221.
A B
A Connected Services con-
tacts
B Ethernet switch contacts
Opening the IRC5 Compact
88.
Continues on next page
181