Job Operations; Operating Prior Print; Printing A Sample During Output And Checking It: Sample Print - Konica Minolta bizhub 1250 User Manual

4.15

Job Operations

4.15 Job Operations
If this machine is equipped with Saddle Stitcher SD-513 and Creaser Unit CR-101, Trimmer Unit TU-503,
or Folding Unit FD-504, job operations may differ from normal operations.
4.15.1

Operating Prior Print

When Prior Print is specified to temporarily stop the currently output job and first output a ready job in the
active job list, if Saddle Stitcher SD-513 is installed on this machine, it may cause the following cases.
- If the print job in progress is using Saddle Stitcher SD-513 while any output sheets are left inside the
saddle stitcher, the machine suspends printing when a set currently output is completed.
- When Creaser Unit CR-101 or Trimmer Unit TU-503 is attached to Saddle Stitcher SD-513, if fold &
staple or multi half-fold is used in combination with crease or 2-side slitting and if any output sheets are
left inside any of the machine, the machine suspends printing when a set currently output is completed.
- If the suspended job is using Saddle Stitcher SD-513 while no output sheets are left inside the saddle
stitcher, the machine starts output for the top-priority job instead of the suspended job after restarting
the operation.
4.15.2

Printing a Sample during Output and Checking it: Sample Print

Some types of print job do not allow you to check the output images till all the machine operations are com-
pleted. Use Sample Print to deliver a sample image to another tray without interrupting the job in process, so
that you can check the quality of printed images at that time.
Sample printing is possible for a job that is folded & stapled and output using Saddle Stitcher SD-513. See
the User's Guide supplied with this machine for details on sample printing.
Saddle Stitcher SD-513
4
4-91