Structure; Part Names Of Servo Amplifier - Mitsubishi Electric MELSERVO-J2-Super Series Instruction Manual

1. FUNCTIONS AND CONFIGURATION

1.6 Structure

1.6.1 Part names of servo amplifier

(1) MR-J2S-100CP-S084 or less
MODE UP DOWN SET
Name/Application
Battery holder
Contains the battery for absolute position data backup.
Battery connector (CON1)
Used to connect the battery for absolute position data
backup.
Display
The 5-digit, seven-segment LED shows the servo
status and alarm number.
Operation section
Used to perform status display, diagnostic, alarm,
parameter and point table setting operations.
UP DOWN
MODE
I/O signal connector (CN1A)
Used to connect digital I/O signals.
I/O signal connector (CN1B)
Used to connect digital I/O signals.
MR-J2S-T01 connector (CN3)
Connector for connection of the MR-J2S-T01 CC-Link
option unit.
Name plate
Charge lamp
Lit to indicate that the main circuit is charged. While
this lamp is lit, do not reconnect the cables.
Encoder connector (CN2)
Connector for connection of the servo motor encoder.
Main circuit terminal block (TE1)
Used to connect the input power supply and servo
motor.
Control circuit terminal block (TE2)
Used to connect the control circuit power supply and
regenerative brake option.
Protective earth (PE) terminal (
Ground terminal.
1 - 14
SET
Used to set data.
Used to change the
display or data in each
mode.
Used to change the
mode.
)
Reference
Section5.5
Section5.5
Chapter8
Chapter8
Section4.3
Section4.3
Chapter7
Section15.1.4
Section1.4
Section4.3
Section15.1.4
Section4.7
Section4.7
Section15.1.1
Section4.10