Mitsubishi Electric MELSERVO-J2-Super Series Instruction Manual page 222

7. SERVO CONFIGURATION SOFTWARE
(1) Point table No. setting ( a) )
Enter the point table No. into the "Point table No." input field and press the enter key.
(2) Servo motor start ( b) )
Click the "Start" button to rotate the servo motor.
(3) Temporary stop of servo motor ( c) )
Press the "Pause" button to stop the servo motor temporarily.
Click the "Start" button to resume rotation.
(4) Servo motor stop ( d) )
Click the "Pause" button again during a temporary stop of the servo motor to clear the remaining
moving distance.
(5) Single-step feed window closing ( e) )
Click the "Close" button to cancel the single-step feed mode and close the window.
(6) Cancel of single-step feed
To cancel single-step feed, switch off the power of the servo amplifier.
7 - 19