Parameters; Parameter List; Parameter Write Inhibit - Mitsubishi Electric MELSERVO-J2-Super Series Instruction Manual

6. PARAMETERS

6. PARAMETERS
CAUTION

6.1 Parameter list

6.1.1 Parameter write inhibit

In the servo amplifier, its parameters are classified into the basic parameters (No.0 to 19), expansion
parameters 1 (No.20 to 53), expansion parameters 2 (No.54 to 77), special parameters 1 (No.78 to 90)
special parameters 2 (No. 91 to 99) and option unit parameters (No. 100 to 124) according to their safety
aspects and frequencies of use. In the factory setting condition, the customer can change the basic
parameter values but cannot change the expansion parameter 1 2 values and special parameter 1 2
values. When fine adjustment, e.g. gain adjustment, is required, change the parameter No.19 setting to
make the expansion parameters write-enabled.
The following table lists the parameters whose values are made valid for reference/write by setting
parameter No. 19. Operation can be performed for the parameters marked
Parameter
Operation
No.19 setting
Reference
0000
(initial value)
Write
Reference
000A
Write
Reference
000B
Write
Reference
000C
Write
Reference
000E
Write
Reference
000F
Write
Reference
000AB
Write
Never adjust or change the parameter values extremely as it will make operation
instable.
POINT
Set "000E" when using the Servo Configuration Software to make device
setting.
After setting the parameter No.19 value, switch power off, then on to
make that setting valid.
Basic Expansion
parameters parameters 1
No.0 to No.19 No.20 to No.53
No.19 only
No.19 only
Expansion Special
parameters 2 parameter 1
No.54 to No.77 No.78 to No.90
6 - 1
.
Special Option unit
parameter 2 parameter
No.91 to No.99 No.100 to 124