Mitsubishi Electric MELSERVO-J2-Super Series Instruction Manual page 183

6. PARAMETERS
(2) Detail list
Class No. Symbol
Command system, regenerative brake option selection
0 *STY
Used to select the command system and regenerative brake option.
0
Feeding function selection
1 *FTY
Used to set the forward rotation start coordinate system and feed length
multiplying factor.
Name and Function
0
Selection of command system
(Refer to Section 5.2)
0: Absolute value command system
1: Incremental value command system
Selection of regenerative brake option
(Refer to Section 15.1.1)
0: Not used (Built-in regenerative brake resistor is used)
1: FR-RC, FR-BU
2:MR-RB032
3:MR-RB12
4:MR-RB32
5:MR-RB30
6:MR-RB50
8:MR-RB31
9:MR-RB51
Select the regenerative brake option that is compatible with
the servo amplifier.
Selection of an incompatible option will result in a parameter
error.
0
Forward rotation start coordinate system selection
(Refer to Section 5.2.2 to 5.2.4)
0: Address is incremented in CCW direction
1: Address is incremented in CW direction
When "1" is set, pressing the start switch for test
operation starts rotation in the reverse direction.
Feed length multiplication factor (STM)
(Refer to Section 5.2.2 to 5.2.4)
0: 1 time
1: 10 times
2: 100 times
3: 1000 times
Servo-on (RYn0) -off, forced stop (EMG) -off
follow-up for absolute value command
in incremental system
0: Invalid
1: Valid
Normally, when this servo amplifier is used
in the absolute value command method of the
incremental system, placing it in a servo off or
forced stop status will erase the home position.
When "1" is set in this parameter, the home
position will not be erased if the servo amplifier
is placed in a servo off or forced stop status.
Operation can be resumed when servo-on (SON)
is turned on again or forced stop (EMG) is canceled.
6 - 6
Initial Setting
Unit
value range
0000 Refer to
Name
and
function
column.
0000 Refer to
Name
and
function
column.