Manual Home Position Return Mode; Outline Of Home Position Return - Mitsubishi Electric MELSERVO-J2-Super Series Instruction Manual

5. OPERATION

5.4 Manual home position return mode

5.4.1 Outline of home position return

Home position return is performed to match the command coordinates with the machine coordinates. In
the incremental system, home position return is required every time input power is switched on. In the
absolute position detection system, once home position return is done at the time of installation, the
current position is retained if power is switched off. Hence, home position return is not required when
power is switched on again.
This servo amplifier has the home position return methods given in this section. Choose the most
appropriate method for your machine structure and application.
This servo amplifier has the home position return automatic return function which executes home
position return by making an automatic return to a proper position if the machine has stopped beyond or
at the proximity dog. Manual motion by jog operation or the like is not required.
(1) Manual home position return types
Choose the optimum home position return according to the machine type, etc.
Type
Dog type home position
return
Count type home
position return
Data setting type home
position return
Stopper type home
position return
Home position ignorance
(Servo-on position as
home position)
Dog type rear end
reference
Count type front end
reference
Dog cradle type
Note: The Z-phase signal is a signal recognized in the servo amplifier once per servo motor revolution and cannot be used as an output
signal.
Home position return method
With deceleration started at the front end of a
proximity dog, the position where the first
Z-phase signal is given past the rear end of the dog
or a motion has been made over the home position
shift distance starting from the Z-phase signal is
defined as a home position.(Note)
With deceleration started at the front end of a
proximity dog, the position where the first Z-phase
signal is given after advancement over the preset
moving distance after the proximity dog or a motion
has been made over the home position shift distance
starting from the Z-phase signal is defined as a
home position.
The position reached after any automatic motion is
defined as a home position.
The position where the machine stops when its part
is pressed against a machine stopper is defined as a
home position.
The position where servo is switched on is defined as
a home position.
The position where the axis, which had started
decelerating at the front end of a proximity dog, has
moved the after-proximity dog moving distance and
home position shift distance after it passed the rear
end is defined as a home position.
The position where the axis, which had started
decelerating at the front end of a proximity dog, has
moved the after-proximity dog moving distance and
home position shift distance is defined as a home
position.
The position where the first Z-phase signal is issued
after detection of the proximity dog front end is
defined as a home position.
General home position return method using a
proximity dog.
Repeatability of home position return is
excellent.
The machine is less burdened.
Used when the width of the proximity dog
can be set greater than the deceleration
distance of the servo motor.
Home position return method using a
proximity dog.
Used when it is desired to minimize the
length of the proximity dog.
No proximity dog required.
Since the machine part collides with the
machine be fully lowered.
The machine and stopper strength must be
increased.
The Z-phase signal is not needed.
The Z-phase signal is not needed.
5 - 23
Features