CODE 128
Code 128 Transmit Function Characters
Enables/disables transmission of Code 128 function characters 1, 2, 3, and 4.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You'll need to cover any unused bar‐
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
DEFAULT
02C701(CR)
Code 128 Transmit Function Characters = Enable
PRODUCT REFERENCE GUIDE
Disabled is the recommended setting for all interfaces.
NOTE
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
Mode barcode.
ENTER/EXIT PROGRAMMING MODE
02C700(CR)
Code 128 Transmit Function Characters = Disable
211