Codabar Start Stop Character Match - Datalogic Magellan 1500i Product Reference Manual

CODABAR

Codabar Start Stop Character Match

Enables/disables the requirement that Codabar start and stop characters match.
To set this feature:
1. Scan the Enter/Exit Programming Mode barcode at the top of the page.
2. Scan either the enable or disable barcode below. You'll need to cover any unused bar‐
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
DEFAULT
023201(CR)
Codabar Start Stop Character Match = Enable
PRODUCT REFERENCE GUIDE
codes on this and the facing page to ensure that the scanner reads only the barcode
you intend to scan.
Mode barcode.
ENTER/EXIT PROGRAMMING MODE
023200(CR)
Codabar Start Stop Character Match = Disable
229